Because of the differences in function, some of the inner gears of the Singer machines are different.For machines that open at the head, remove the two screws found on the top cover to release the cover and expose the gears.
In the models where the cover lifts straight up, the screws are found along the top between the spool pin and the take-up lever. In the models where the covers are pulled off the side, the screws are found on the side of the machine in the middle of the sewing head and about an inch from the wheel. On these machines, you must remove a metal plate at the bottom of the machine with two large screws on each end of the plate and four small screws in a square in the middle of the plate. This is the metal bar that runs from the front, the needle shaft, to the back, the hand wheel, of all Singer sewing machines made in any year. Unscrew the wheel from the base and pull the wheel shaft and wheel out of the machine. Turn these screws counterclockwise to release the shaft at the end. The number will depend upon how long the machine is from wheel to needle shaft. Check the bar for any irregularities and replace it if necessary. Tighten the gears with the tool used to loosen them by turning the tool in a clockwise direction.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |